PPS-Compounds-TECACOMP-PPS-TRM-PVX-black
PPS-Compounds-TECACOMP-PPS-TRM-PVX-black

TECACOMP PPS TRM PVX black 1061042

Mechanically and tribologically optimised PPS compound

Polyphenylene sulphide (PPS) is a highly crystalline thermoplastic whose polymers retain their excellent mechanical and chemical resistance even at very high temperatures. Solvents below 200 °C are not known. Many acids and alkalis cannot harm the plastic either. PPS has high strength and stiffness and can be used permanently up to 230 °C and for short periods up to 260 °C. 

By adding carbon fibres, as well as mineral fillers such as graphite and polytetrafluoroethylene (PTFE), the mechanical and tribological properties are additionally strengthened. The PPS compound absorbs only a small amount of moisture and therefore has a high dimensional and creep resistance. TECACOMP PPS TRM PVX black is used primarily in mechanical engineering and vehicle construction.

Facts

Chemical designation
PPS (Polyphenylensulfide)
Colour
black
Density
1.5 g/cm3

Main Features

  • good slide and wear properties
  • very good chemical resistance
  • high dimensional stability
  • high stiffness
  • high creep resistance
  • high heat deflection temperature
  • inherent flame retardant

Target industries

Downloads

Technical details


  • product-technical-detail-collapse-item-0-lvl-1
    Mechanical properties Value Unit Parameter Norm
    Tensile strength 134 MPa DIN EN ISO 527-1
    Modulus of elasticity
    (tensile test)
    14100 MPa DIN EN ISO 527-1
    Elongation at break (tensile test) 1,2 % DIN EN ISO 527-1
    Impact strength (Charpy) 17 kJ/m2 DIN EN ISO 179-1eU
  • product-technical-detail-collapse-item-1-lvl-1
    Thermal properties Value Unit Parameter Norm
    Glass transition temperature 90 C -
    Melting temperature 280 C -
    Heat distortion temperature 270 C ISO-R 75 Method A
    Service temperature 260 C short term -
    Service temperature 230 C long term -
  • product-technical-detail-collapse-item-2-lvl-1
    Other properties Value Unit Parameter Norm
    Molding shrinkage 0,2 % longitudinal DIN EN ISO 294-4
    Molding shrinkage 0,8 % transverse DIN EN ISO 294-4
    Water absorption 0,1 % 23 °C / 50 % relative humidity up to saturation DIN EN ISO 62
  • product-technical-detail-collapse-item-3-lvl-1
    Processing parameter Value Unit Parameter Norm
    processing temperatures 300 - 340 C -
    Mould temperature 135 - 155 C -
  • product-technical-detail-collapse-item-4-lvl-1
    Predrying Value Unit Parameter Norm
    Permissible residual moisture content 0,05 % -
    Drying temperature 140 - 150 C -
    Drying time 2 - 4 h -