PA66-Compounds-TECACOMP-PA66-TRM-XS-black
PA66-Compounds-TECACOMP-PA66-TRM-XS-black

TECACOMP PA66 TRM XS black 1014962

Polyamide 66 with optimised sliding and wear properties

PA66 is a semi-crystalline engineering plastic that can be used in temperature ranges up to 110 °C, and for short periods up to 170 °C, for a wide range of applications. The good mechanical properties of the base polymer were further improved with carbon fibers and mineral fillers. The tribologically and mechanically optimised compound has proved particularly successful in mechanical engineering and vehicle construction.

TECACOMP PA66 TRM XS has a density of only 1.31 g/cm3 and, in addition to its good tribological properties, is also electrically conductive. The carbon fibers increase tensile, compressive and wear resistance. Carbon also has a less abrasive effect on the mating partner than glass fibers, for example, and dissipates heat in a better way.

Facts

Chemical designation
PA 66 (Polyamide 66)
Colour
black
Density
1.31 g/cm3

Main Features

  • good slide and wear properties
  • very high stiffness
  • good wear properties
  • good heat deflection temperature
  • resistant to many oils, greases and fuels
  • good weldable and bondable
  • low viscosity

Target industries

Downloads

Technical details


  • product-technical-detail-collapse-item-0-lvl-1
    Mechanical properties Value Unit Parameter Norm
    Tensile strength 200 MPa DIN EN ISO 527-1
    Modulus of elasticity
    (tensile test)
    18500 MPa DIN EN ISO 527-1
    Elongation at break (tensile test) 2,0 % DIN EN ISO 527-1
    Impact strength (Charpy) 40 kJ/m2 DIN EN ISO 179-1eU
  • product-technical-detail-collapse-item-1-lvl-1
    Thermal properties Value Unit Parameter Norm
    Glass transition temperature 5 - 72 C -
    Melting temperature 260 C -
    Heat distortion temperature 255 C ISO-R 75 Method A
    Service temperature 170 C short term -
    Service temperature 110 C long term -
  • product-technical-detail-collapse-item-2-lvl-1
    Electrical properties Value Unit Parameter Norm
    volume resistivity 100 Ω*m DIN EN ISO 3915
  • product-technical-detail-collapse-item-3-lvl-1
    Other properties Value Unit Parameter Norm
    Molding shrinkage 0,4 % longitudinal DIN EN ISO 294-4
    Molding shrinkage 1,0 % transverse DIN EN ISO 294-4
    Water absorption 1,8 % 23 °C / 50 % relative humidity up to saturation DIN EN ISO 62
  • product-technical-detail-collapse-item-4-lvl-1
    Processing parameter Value Unit Parameter Norm
    processing temperatures 270 - 310 C -
    Mould temperature 80 - 110 C -
  • product-technical-detail-collapse-item-5-lvl-1
    Predrying Value Unit Parameter Norm
    Permissible residual moisture content 0,1 % -
    Drying temperature 80 - 120 C -
    Drying time 4 - 8 h -