TECACOMP PEEK XT TRM PVX black 1061177

Tribologically optimised PEEK with increased heat resistance

add to list
product enquiry
request sample
Request injection molded part

Polyetheretherketone (PEEK) is one of the thermoplastics with the highest chemical and thermal resistance. Thanks to an optimised polymer structure, this compound has increased heat resistance. It can be used up to 260 °C permanently and up to 300 °C for short periods. The glass transition temperature is 170 °C, the melting point 385 °C, i.e. around 20 °C and 40 °C higher than standard PEEK.

The addition of carbon fibres further improves the mechanical strength and modulus of elasticity of TECACOMP PEEK XT TRM PVX. Mineral fillers such as graphite and polytetrafluoroethylene (PTFE) provide intrinsic solid lubrication and also enable dry-running applications.

Facts

Chemical designation
PEEK (Polyetheretherketone)
Colour
black
Density
1.41 g/cm3

Main Features

  • good slide and wear properties
  • good wear properties
  • high thermal and mechanical capacity
  • high creep resistance
  • very high heat deflection temperature
  • very good chemical resistance
  • hydrolysis and superheated steam resistant
  • high dimensional stability

Target industries

automotive industry
mechanical engineering

Downloads

Datasheet (PDF)

Technical details

  • product-technical-detail-collapse-item-0-lvl-1
    Mechanical properties Value Unit Parameter Norm
    Tensile strength 148 MPa DIN EN ISO 527-1
    Modulus of elasticity
    (tensile test)    		 11500 MPa DIN EN ISO 527-1
    Elongation at break (tensile test) 2,3 % DIN EN ISO 527-1
    Impact strength (Charpy) 33 kJ/m2 DIN EN ISO 179-1eU
  • product-technical-detail-collapse-item-1-lvl-1
    Thermal properties Value Unit Parameter Norm
    Glass transition temperature 170 C -
    Melting temperature 385 C -
    Heat distortion temperature 325 C ISO-R 75 Method A
    Service temperature 300 C short term -
    Service temperature 260 C long term -
  • product-technical-detail-collapse-item-2-lvl-1
    Electrical properties Value Unit Parameter Norm
    surface resistivity 109 Ω DIN EN 61340-2-3
    volume resistivity 107 Ω*m DIN EN 61340-2-3
  • product-technical-detail-collapse-item-3-lvl-1
    Other properties Value Unit Parameter Norm
    Molding shrinkage 0,4 % longitudinal DIN EN ISO 294-4
    Molding shrinkage 1,1 % transverse DIN EN ISO 294-4
    Water absorption 0,1 % 23 °C / 50 % relative humidity up to saturation DIN EN ISO 62
  • product-technical-detail-collapse-item-4-lvl-1
    Processing parameter Value Unit Parameter Norm
    Cylinder/processing temperature 390 - 425 C -
    Mould temperature 190 - 230 C -
  • product-technical-detail-collapse-item-5-lvl-1
    Predrying Value Unit Parameter Norm
    Permissible residual moisture content 0,02 % -
    Drying temperature 150 - 160 C -
    Drying time 2 - 4 h -