TECAMID 66/X GF50 black

PA 66 50% glass fibre reinforced

add to list
product enquiry
request sample
Request machined part
Request customised profile
TECAMID 66/X GF50 black is a PA66 GF50 50% glass fibre filled material based on a partially crystalline polyamide with partial aromatic components for improved thermal stability. In addition to the heat stabilization, this material has been reinforced by a higher percentage of glass fibres than is typically seen with extruded products. As a result, this special glass filled Nylon can be used at high service temperatures up to 130°C under high loads, while still demonstrating very low warpage.

Facts

Chemical designation
PA 66 (Polyamide 66)
Colour
black
Density
1.61 g/cm3

Main Features

  • good heat deflection temperature
  • high thermal and mechanical capacity
  • resistant to many oils, greases and fuels
  • high fatigue strength
  • high dimensional stability
  • very high strength
  • very high creep resistant
  • good machinability

Target industries

mechanical engineering
automotive industry
electronics

Downloads

Datasheet (PDF)
Product handling (PDF)

Technical details

  • product-technical-detail-collapse-item-0-lvl-1
    Mechanical properties Value Unit Parameter Norm
    Modulus of elasticity
    (tensile test)    		 8700 MPa 1mm/min DIN EN ISO 527-2
    Tensile strength 115 MPa 50mm/min DIN EN ISO 527-2
    Tensile strength at yield 115 MPa 50mm/min DIN EN ISO 527-2
    Elongation at yield (tensile test) 2 % 50mm/min DIN EN ISO 527-2
    Elongation at break (tensile test) 2 % 50mm/min DIN EN ISO 527-2
    Flexural strength 200 MPa 2mm/min, 10 N DIN EN ISO 178
    Modulus of elasticity
    (flexural test)    		 9000 MPa 2mm/min, 10 N DIN EN ISO 178
    Compression modulus 6200 MPa 5mm/min, 10 N EN ISO 604
    Compression strength 28/56/141 MPa 1% / 2% / 5% EN ISO 604
    Shore hardness 90 D DIN EN ISO 868
  • product-technical-detail-collapse-item-1-lvl-1
    Thermal properties Value Unit Parameter Norm
    Glass transition temperature 78 C DIN EN ISO 11357
    Melting temperature 256 C DIN EN ISO 11357
    Service temperature 200 C short term NN
    Service temperature 130 C long term NN
    Thermal expansion (CLTE) 4 10-5*1/K 23-60°C, long. DIN EN ISO 11359-1;2
    Thermal expansion (CLTE) 5 10-5*1/K 23-100°C, long. DIN EN ISO 11359-1;2
  • product-technical-detail-collapse-item-2-lvl-1
    Electrical properties Value Unit Parameter Norm
    surface resistivity 1014 Ω -
    volume resistivity 1014 Ω*cm -
  • product-technical-detail-collapse-item-3-lvl-1
    Other properties Value Unit Parameter Norm
    Resistance to hot water/ bases - - -
    Flammability (UL94) HB - listed (value at 0.85mm) DIN IEC 60695-11-10;
    Resistance to weathering (+) - -
    Water absorption 0.1 - 0.2 % 24h / 96h (23°C) DIN EN ISO 62

Stock program